Microaces PERCEE, Инструкция по сборке

Страница: 52 / 52

52
STAGE 10 DETAILS
Spot On!
Nose Heavy
Add weight to Tail!
Tail Heavy
Add weight to Nose!
Centre of Gravity (CoG)
With all the electronics installed including the battery, the CoG should be around the apex of the top wing as shown on
the diagram below.
Balance on finger tips to see if the aircraft balances at this point. Before adding any weight it is advisable to perform a
glide test. Add weight accordingly to obtain a smooth glide.
Glide Test - How to!
Find a suitable test space with a forgiving landing area, e.g. over
long grass or onto soft furnishing. Ensure all control surfaces are
in the neutral position. Gently toss the model straight and level.
Observe the results and add balancing weight if required.
Radio Control Recommendations
If the recommended electronics have been
supplied by Microaces, the receiver will have
been set up to operate with the Percee model. But
please check before flying to ensure flight surfaces
are operating in the required direction and reverse any
that aren’t, on your transmitter* if required.
To enable switching between SR3X stabilization modes,
set up CH5 to operate from one of the transmitter’s 3 way
switches*.
For initial flight tests, a modest amount of exponential* is advised on
aileron, elevator and rudder.
This can be altered as you establish the flight characteristics of your model.
*Consult your transmitter’s user manual.