Micro Seven VM10a, Руководство оператора

Страница: 25 / 32

25
Chapter 6
Changing Auto Start Timer
The screen shows as follows after the screen button is changed to “Auto Run”.
Automatic mode timing in second: 0
Data recording may be done when ‘Record’ is shown
under ‘Auto Run’ switch. Click the ‘Record/No Record’
switch to change the recording mode. Recording during
Auto run mode is stored in different files, which may be
displayed during the ‘Auto Run’ mode by using ‘POP’
switch and the ‘file’ switch to display different files.
The auto start timer is only effective when the “Auto” switch is on after the “Go/Run” is clicked.
To change the auto start timer, click either “SEC +” to increase or “SEC –“ to decrease it.
There is no starting time delay in the continuous auto start mode, but there always is time delay
between measurements.
Select ‘Record’ or ‘No Record’ for storing test result while the screen is showing “Auto Run. For
each starting the Auto Start, new recording starts at file number = 0. To view recorded test result
that were stored during auto start mode, the screen must show “Auto Run”. There is maximum
of one thousand test results that may be stored. See also Chapter 9 DMM data and trace history
files