Page 7
surfaceCONTROL 3D SC2500 / SC2510
7.
Mounting of the Sensor
The sensor can be mounted either on a lightweight tripod, on a robust column stand from
the optional accessories or on a robot.
Mount the tripod according to its assembly instructions.
When using the tripod, ensure that the tripod with the sensor has a stable position to avoid
any tipping over of the system.
i
Ensure that you can hold the sensor securely during assembly. If necessary, have a
second person assist.
Ensure careful handling during installation and operation.
Damage to or destruction of the sensor.
i
Use the built-in spirit level for the tripod for adjustment of the tripod.
8.
Dismantling
Proceed as follows if you would like to detach the sensor from the tripod again:
Only for column stand option with boom:
Secure the boom of the tripod with the help of the clamping lever or
retract the boom all the way and secure it with the clamping lever,
see also assembly instructions for the tripod.
Risk of injury. Boom without sensor makes jerky upward movement
due to the counterweight in the tripod. Secure the boom using the
clamping lever.
Undo the upper knurled screw on the tilt head of the tripod.
Press the red locking pin on the tilt head of the tripod and pull the sensor with the
tripod out in the longitudinal direction.
i
Ensure that you can hold the sensor securely while pulling out. If necessary, have a
second person assist.
Ensure careful handling during installation and operation.
Damage to or destruction of the sensor.
