Page 5
surfaceCONTROL 3D SC2500 / SC2510
Sensor Control (USB)
Pin
Signal
Pin
Signal
1
USB D+
3
USB VCC
2
USB D-
4
GND
Fig. 4 Pin assignment connector USB port
The cable shield is connected to the connector housing.
The sensor is configured and controlled via the available USB 2.0 interface. Use only the
supplied USB cable.
A 4-pin LEMO PushPull connector is used on sensor side.
The USB-A connector on controller side can be connected to a USB 2.0 or USB 3.0 port.
Image Data Transmission (Gigabit Ethernet)
Pin
Signal
Pin
Signal
1
Data1+
5
Data3-
2
Data1-
6
Data2-
3
Data2+
7
Data4+
4
Data3+
8
Data4-
Fig. 5 Pin assignment connector “Ethernet port”
For the image data output of the cameras via Gigabit Ethernet, the sensor has two Gigabit
Ethernet interfaces. The sensor supports only the transmission with 1 Gbit. 8-pin, X-coded,
M12 round connectors with screwed connections are used on sensor side. The connec-
tion and tightening of the Ethernet cable to the sensor can be done by hand and does not
require any tools. Proceed as follows for this:
Carefully insert the cable connector into the port on the sensor.
Turn the cable connector until you feel the latching of the inner groove into the corre-
sponding guide of the port.
RJ45 connectors are used on the PC side.
i
Use only the Ethernet cable sup-
plied in the scope of delivery.
Fig. 6 Connecting Ethernet connector to port
Tighten the cable connector.
