1.
Warnings
Do not look directly into the light source of the sensor.
> Risk of injury, damage to the eyes and skin
Connect the power supply and the display/output device according to the safety regula-
tions for electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the sensor and the controller. The supply voltage must not
exceed the specified limits. Avoid constant exposure of the sensor to dust or splashes of
water by taking suitable measures such as blowing off or using a protective housing. The
sensor housing may only be opened by authorized persons.
> Damage to or destruction of the sensor and/or the controller
Do not touch the protective windows. Remove any fingerprints immediately using pure
alcohol and a clean cotton cloth without leaving any streaks. Protect the cables against
damage.
> Failure of the measuring device
Only plug in or disconnect devices when disconnected from the power supply.
2.
Notes on CE Marking
The following apply to the surfaceCONTROL 3D 25x0 measuring system:
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU
Products which carry the CE mark satisfy the requirements of the EU directives cited and
the relevant applicable harmonized European standards (EN). The measuring system is
designed for use in industrial environments.
The EU Declaration of Conformity and the technical documentation are available to the
responsible authorities according to the EU Directives.
Assembly Instructions
surface
CONTROL
3D SC2500 / SC2510
