Page 2
scanCONTROL 25xx
4.
Laser Safety
The scanCONTROL 25xx/BL sensors operate with a semiconductor laser with a
wavelength of 405 nm (visible/blue). Operation of the laser is indicated visually by the
LED on the sensor, see operating instructions Chap. 3.3.
When operating the scanCONTROL 25xx/BL sensors, the relevant regulations accord-
ing to IEC 60825, Part 1 of 05/2014 and the applicable accident prevention regulations
must be followed. The laser warning labels for Germany have already been attached.
For other non German speaking countries, an IEC standard label is included in delivery
and the versions valid for the user’s country must be attached before the device is put
into operation for the first time.
i
If both warning labels are covered over when the unit is installed, the user must
ensure that supplementary labels are attached.
Laser Class 2M
The sensors fall within laser class 2M (IIM). The laser is operated on a pulsed mode,
the
maximum optical power is ≤ 8 mW.
Laser radiation. Close your eyes or immediately turn away if the
laser beam hits the eye. Irritation or injury of the eyes possible.
Attach the following warning labels to the cover (front and rear side) of the sensor
housing.
Laser warning sign and laser label LLT25xx-25/BL, LLT25xx-50/BL, LLT25xx-100/BL
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR CONFORMANCE WITH
IEC 60825-1 ED. 3., AS DESCRIBED IN
LASER NOTICE NO. 56, DATED MAY 8, 2019
Only for USA
i
Mark the laser area recognizable
and everlasting.
