MICRO-EPSILON optoNCDT ILR 1191, Инструкция по эксплуатации

Страница: 10 / 64

Page 10
Laser Class
optoNCDT ILR 1191
2. Laser Class
The optoNCDT ILR 1191 sensor operates with semiconductor lasers for measurement and adjustment of the
sensor.
Laser class Laser type, wavelength
Measuring laser 1 (I)
EN60825-1:2003-10 infrared, 905 nm, invisible
beam divergence: 1.7 mrad
Pilot laser for
mounting/adjustment 2 (II)
EN60825-1:2007 / IEC825-1 red, 635 nm, visible
Class 1/2 (I/II) lasers are not notifiable and a laser protection officer is not required either.
The housing of the optical sensors may only be opened by the manufacturer. For repair and service purposes
the sensors must always be sent to the manufacturer.
The laser warning labels for Germany have already been applied. Those for other non German-speaking
countries an IEC standard label and the label for USA are included in delivery and the versions applicable to
the user‘s country must be applied before the equipment is used for the first time.
The following warning label is attached on the sensor housing (bottom side):
t=10 ns Q=210 nJ f=2 kHz

=905 nm
VISIBLE AND INVISIBLE LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
EN 60825-1: 2007  =635 nm P=1 mW CW
THIS PRODUCT COMPLIES
WITH FDA REGULATIONS
21CFR 1040.10 AND 1040.11
IEC label Only for USA
i
If both warning labels are disguised in operation mode the user must add additional warning labels.
During operation of the sensor the pertinent regulations according to EN 60825-1 on “radiation safety of laser
equipment“ must be fully observed at all times. The sensor complies with all applicable laws for the manufac-