MICRO-EPSILON ELTROTEC Endolight FOT Halogen 150, Инструкция по эксплуатации

Страница: 12 / 28

Page 12
Operation
ELTROTEC Endolight FOT Halogen 150
5. Operation
5.1 Getting Ready for Operation
Check the built-in heat filter for possible break.
> Damage to the iris diaphragm and the connected fiber optics by excessive heat development
i
Set the iris diaphragm control lever ( 3 ), see Chap. 4.2 , initially at minimum position (left) to prevent
glare.
5.2 Commissioning
The light source is supplied as standard for the connection to 230 VAC operating voltage, see Chap. A 3 .
Replug the voltage selector ( 8 ) for 110 VAC operating voltage by setting the
115
to the positioning ar-
row ( 8 ), see Chap. 5.3 .
i
The terminals 120 Volt (positioning arrow ( 2 ) is on
125, see Chap. 5.3
.) and 240 Volt (position-
ing arrow ( 2 ) is on
250, see Chap. 5.3
.) are not occupied and cannot be used.
If the voltage selector has this setting, the light source can therefore not be used.
Connect the supplied power supply cable to the power input ( 9 ), see Chap. 4.2 and the power supply.
Connect the fiber optic cable to the fiber optic connection ( 5 ), see Chap. 4.2 .
Some fiber optic cables (e.g. multi-armed gooseneck fiber optic cables) and adapters are fitted with a cam
(anti-rotation device), which enters the anti-rotation device keyway ( 4 ), see Chap. 4.2 , to prevent rotation of
the connector.
Press the
ON
/
OFF
switch ( 7 ), see Chap. 4.2 .
The control lamp lights up. The light source is ready to operate.
Check Always after switching on whether the built-in fan runs (noise).
> Destruction of the lamp, the heat protection filter and the iris diaphragm due to excessive heating.
i
In case of a defective fan, turn the light source off immediately.
NOTICE
NOTICE