8
©2021 Micro-Air Corp
July 1, 2021, revision 1.8
8.
The zone selection button will show a zone in green when it is turned on. The zone number will
show in gray if the zone is not available and in red if there is a fault with the zone. A frame will
show around the zone number to indicate it is selected.
9.
Pressing the gear will change the settings screen to allow additional setup functions.
10.
Pressing the set point will change the system units from °F to °C and back. The set point is also
used as an indicator of system operation. A red set point indicates a heating cycle is in process.
A blue set point indicates a cooling cycle is in process. A white icon indicates no cycle is in
process.
Away screen (Heat and cool set points)
Away operation allows setting upper and lower limits for temperature with a non-operating
area
or “dead band” in
the middle. This can be useful when setting a higher daytime cooling
temperature and lower night time heating temperature. It can also be used to control the temperature
extremes when you are away from the RV. The mode selected must be an automatic mode to allow
both heating and cooling operation.
1. Press the set points area to toggle between the selected values. A blue square will show
around the value you are changing. The upper value changes the cooling set point and the lower value
changes the heating set point.
2. Use the up and down arrows to change the selected temperature value.
