©2021 Micro-Air corp.
3
rev. 1.06
Installing EasyStart
Step 1: Identify the components
Run capacitor
Contactor
The two components shown in figure 1 will
be used to connect your EasyStart. Locate
these components in your air conditioner before proceeding. Some compressors will have additional
components and may have a circuit board as well. Power comes in from the bottom of the contactor
usually from a breaker or fuse panel on the dwelling. This must be disconnected (Turn the breaker off)
before connecting EasyStart.
Step 2: Mounting the unit
EasyStart can be mounted on any flat surface in either a horizontal or vertical position. It can
also be mounted with the clear cover pointing up. The wire entry must face down when EasyStart is
mounted vertically.
Figure 1
