Installation(Note: Outlet Pipe is not supplied, you will need
to purchase separately)
Warning !
The hood should be installed by a suitably qualified person.
All fixing screws, nuts and bolts required are supplied.
Note. The flexible Outlet Pipe is not supplied with this rangehood unit
BUT must be included in installation, please purchase from the retailer.
Height Recommendations
Gas Cooker
- The unit should be fitted so that the lower edge of the hood is
approximately 75cm above the cooking plate surface minimum.
Electric Cooker
- The unit should be fitted so that the lower edge of the
hood is approximately 65cm above the cooking plate surface minimum.The
hood should not be more than 80cm above the cooker surface to maintain
efficiency.
Step 1
. Fix the outlet pipe to the hood as shown (ST 3.9 x 10 screw)
Step 2
. Note. The unit is supplied with a wall bracket and a bracket
that attaches to the Inner Duct. The wall bracket is secured to the
wall and the hood then simply hooks onto the wall bracket when
assembled.
To fit the hood bracket to the inner duct align the inner duct holes to
the wall bracket holes and secure together (M4 Screw)
2
The stainless range hood is attached with charcoal filters, on the
sides of the motor as below. To replace the charcoal filters please
see instructions below. Replacement charcoal filters can be
purchased from the retailer.
A
B
Important Safety Instructions
!
Before using this appliance please read and fully understand the
safety directions in this manual. Ensure that you know how to operate
the appliance. All electrical equipment presents a risk to the end user.
We ask that you use this appliance in a sensible safe manner in
accordance with the instructions supplied for your own safety.
If for any reason the appliance does not function correctly or shows
signs of damage please return it immediately to the retailer or contact
the
help line.
New Zealand call toll free 0508 ASIAPAC (274 2722)
Australia call +64 9 974 9206
5
