Battery Type:
It means the type of the battery placed in the current channel.
Energy percentage:
It means the current energy percentage for the battery
placed in the current channel.
Battery test and error report
Battery activation and test
Reverse connection of battery The symbol about the battery placed in
the current channel flashes and the code
is also displayed simultaneously.
Short circuit of battery
After the battery is placed rightly and proved normal, normal charging
operation commences.
Prompt about error report
1. Connection with power supply.
2. Place a battery into any channel and then, the charger could automatically
distinguish the battery type and commences testing relevant battery
parameters which would be displayed in a LCD
.
3. If the charger is not set up specially, the charger could automatically
distribute the charging current based on the internal resistance of the battery.
4. Press the key in a short time to switch over the information displayed
respectively about one of the channels C1-C4. Meanwhile, the LCD
backlight would be illumed.
Direction for operation
The charger is unable to automatically distinguish LiFePO4 / 4.35V Li-ion
battery. The user shall select the battery type by manual operation. If
there is no manual setting made to a LiFePO4 battery, a standard
charging would be launched which is exclusively applicable to Li-ion 4.2V battery,
which would means a risk of explosion.
The charger is only compatible with lithium-ion battery, IMR, INR, ICR, lithium iron
phosphate battery(LiFePO4 battery) and Ni-MH/Ni-Cd batteries. Its charging aiming
at the battery beyond those mentioned above may cause explosion, battery
breakage or leakage, personal injury or property loss.
After full capacity is achieved, the word would be displayed in the
LCD and it means that the charger had automatically stopped charging
because overcharging would shorten the normal service life of the battery.
Note: When a Ni-MH battery which is charged fully and also indicated by the
word Full accordingly is taken down from the charger and then placed into the
same charger again soon after, if an energy percentage of 70% and even
lower is shown, it is normal because of the characteristic of the Ni-MH battery.
Automatic charging stop after full charge
03
