Prodomus
14
To remove the turbo brush press the release button at the back of the brush and pull off.
Please note that there is a supply cable inside of the turbo brush. Never turn the brush
too far to the left or right side manually. Otherwise the supply cable inside could get
damaged.
Note: This appliance is an accumulator operated hand and floor vacuum cleaner for
cordless use. Always charge the accu batteries before each use as described in
chapter „Charging“.
Wall mount
Caution! The place were the wall mount is fixed should be dry and not reachable for
children. Ensure to mount it not next to heating sources, direct sun light, humidity and
sharp edges to avoid any damage.
If desired fix the wall mount at the wall next to a socket.
Engage the appliance into the wall mount.
Plug the charger into the small plug at wall mount and the power plug into a socket nearby.
Store the appliance always in plugged and in the wall mount to guarantee that it is always
ready for use.
You can mount the wall mount to the wall or you can fix the stand foot at the wall mount to
use it as a mobile charging and storing unit (see below).
Stand foot
mounting of the stand foot mobile charging and storing unit
Charge the appliance as described under “Charging”.
Charging
Always make sure that the appliance is switched OFF. A charging time of approx. 14-16
hours is required for initial use. To charge/recharge plug the small charger of the adapter
into the charging station and the power plug into a 230 V AC electrical outlet. The charge
control lamp at the hand vacuum cleaner indicates charging as long as plugged. If entirely
discharged after use charge minimum of approx. 14-16 hours.
If charge control lamp is not illuminated, check if the outlet is powered and if the jack of the
charger is properly seated in the charging socket.
You may leave your cleaner on charge continuously so that it is always ready for use. There
is no risk of overcharging.
Please see also the accumulator recycling notes in the chapter “Disposal”.
