3
Positioning of Gas Burner
Burner is composed of burner cap, burner body
and burner base. Place the burner cap and
burner body onto the burner base without
tilting.
Ignition of Gas Burner
Press and rotate the knob anti-clockwise to the
maximum position. Electric sparks from ignition
electrode ignite the burner. After ignition, keep
pressing the knob for 5 seconds. After releasing
the knob, make sure the flame persists.
Turn the knob to adjust flame power according
to cooking needs. The minimum position is at
the end of the anti-clockwise rotation direction.
Overheat protection device is equipped
internally. If cooking spillage blocks burner and
incurs abnormal combustion, flame will be
extinguished automatically to ensure safety.
Attention: When the appliance is operating at
low flame, do not open underneath cabinet
door rapidly; otherwise, flame may be
extinguished by air draught.
Maintenance
Prior to any cleaning and maintenance
operation, disconnect the gas hob from the
power supply. Allow the appliance to cool down
before performing any maintenance and
cleaning. Wear gloves to protect the hands while
cleaning.
To maintain the appliance properly, follow the
following instructions to clean it regularly:
do not use steam cleaners for cleaning;
the glass, metal and enameled parts must be
cleaned with suitable non-abrasive and non-
corrosive detergents. Avoid chlorine-based
detergents (bleach, etc.);
avoid leaving acid or alkaline substances on
the gas hob (vinegar, salt, lemon juice, etc.);
clean and tidy up the burner after spillage of
food and liquid once it cools down;
the burner caps and burner bodies
(detachable parts of the burner) must be
washed frequently with warm water and
detergent, taking care to remove any grime
and keep the flame holes of burner body
away from blockage;
dry the burner caps and burner bodies
completely after wash and check that none
of the flame hole of burner body clogged;
refix burner cap and burner body onto
burner base. Ensure that it is not tilted or
reversed;
in case that stains get stuck at safety sensor
or ignition electrode, clean them with soft
brush.
Operating Instructions
Max.
Min.
Close
Burner Cap
Burner Body
Burner Base
