2
Installation Position
Install the appliance in a well-ventilated room
and keep it away from any combustible or
flammable objects such as paper, oil, sprays or
pressurized containers. The appliance should be
installed with a distance of more than 150mm
away from surrounding combustible materials.
Allow 760mm or more clearance above
appliance.
Reserve cut hole on bench-top according to
Fig.1. Depth of bench-top should be 600mm or
more. Sealing gasket should be affixed around
the entire periphery of top plate bottom of
appliance (Fig.2). Keep a clearance from the
surrounding objects according to Fig.3. The
appliance should be fixed to the bench-top by
mounting brackets (Fig.4).
If another appliance (e.g. dishwasher, washer,
etc.) is to be installed under the gas appliance,
keep a clearance of at least 20mm from the
bottom of the appliance. If the installation
instructions of the appliance underneath
requires a different distance, adopt the larger
value (Fig.3).
If an air-flow generating appliance or device
(such as built-in oven, clothes dryer) is to be
installed under the built-in gas appliance, a
partition shelf must be added and sealed with
silicon gel. This prevents air draught affecting
the built-in hob operation.
Gas connection
Connect the gas appliance to the gas supply
according to the prescribed standards in force,
and ensure that the appliance matches with the
type of gas supply. Furthermore, check that the
supply pressure is 1.5 kPa and governor
pressure is 1.0 kPa.
Attention:
The gas supply pipe connection of the
appliance is ½” threaded male end. Use
approved gas tubing for connecting to
appliance. Flexible tubing must not be
longer than 2000 mm. Once connection
has been carried out, make sure that the
pipe does not touch any moving parts and
is not kinked or compressed.
When the installation has been carried
out, check gas soundness of piping. Never
use naked flame for checking.
Electrical connection
Power supply connection must be undertaken
by qualified person. Prior to carrying out the
electrical connection, please ensure that:
The power supply follows what is indicated
on the badge label of appliance;
The power supply system provides effective
earth connection, following the standards
and law provisions in force. The earth
connection is compulsory according to the
law.
The power supply point should be a 13A socket
in compliance with BS 1363. It should be easily
accessible. Connect the power cable of appliance
with 13A plug in compliance with BS 1363.
Insert power plug and turn on power.
If the power cable
is
damaged, contact Towngas
Company to rectify it.
Installation
(Fig.2)
(Fig.4)
20mm
≥760mm
(Fig.3)
345mm
486mm
(Fig.1)
≥600mm
≥55mm
