5
When unpacking the unit, if you find damage due to shipping, contact your dealer or
Mi-T-M Corporation
immediately,
HOT PRESSURE WASHER MODE
(P Units only)
SET-UP PROCEDURE:
1. Connect water supply to inlet on back of unit (minimum pressure 15 psi and maximum inlet pressure
60 psi) (maximum temperature 55° F or 13° C).
2. Connect high pressure hose and trigger gun to outlet on lower front of unit.
3. Connect electrical supply (fused disconnect)
OPERATING PROCEDURE:
Control (see 'Electrical Control Panel')
Number
8
1. Push "Heater Reset" button - green light comes on
7
2. Move toggle switch to "Pump On" position
5
3. Turn temperature control to desired temperature (see 'Specifications' for maximum
temps.)
6
4. Move toggle switch to "Heater On" position
1&2
5. When cleaning gun trigger is squeezed, the red indicator lights for thermostat
and heater will go on.
2
6. When water reaches desired temperature, the "Heater On" light will shut off as the
unit maintains the desired temperature.
1&2
7. At maximum temperature, both red lights remain on continuously. Both lights shut off
when trigger is released.
SHUT DOWN PROCEDURE:
6
1. Move heater switch to "OFF".
2. Keep trigger depressed until discharge water is cold.
7
3. If unit will be subjected to temperatures below freezing, antifreeze protection
must be applied.
STEAM CLEAN MODE
(S Units only)
SET-UP PROCEDURE:
1. Connect water supply to inlet on back of unit (minimum pressure 15 psi and maximum inlet pressure
60 psi) (maximum temperature 55° F or 13° C).
2. Connect the steam hose and steam wand to outlet on lower front of unit.
OPERATING PROCEDURE:
Control (see 'Electrical Control Panel')
Number
8
1. Push "Heater Reset" button (green light should come on)
7
2. Move toggle switch to "Pump On" position
5
3. Turn temperature control to 305° F (152° C) position
6
4. Move toggle switch to "Heater On" position (red light indicator for the thermostat and until
the maximum temperature is reached)
5. The water flow will change to steam as the temperature increases (about three minutes
until the maximum temperature is reached)
1&2
6. Both red lights should now remain on.
OPERATING INSTRUCTIONS
Содержание EH-2303-0M30
