MHS Boilers CRUZ belt, Инструкция по установке, эксплуатации и обслуживанию, Страница: 9 / 46

CRUZbelt
9
E0032544Rev090710
FLOOR SUPPORT INSTALLATION
1. Set all supports for unit to proper height.
2. Attach supports to both sides of drive.
3. On intermediate and end beds, attach one
support on the end furthest from the drive.
CEILING HANGER INSTALLATION
WARNING
Consult the building architect or structural engineer
regarding ceiling loading and structural limitations of
the building.
WARNING
Consult your distributor or a structural engineer to
determine hanger and header steel sizes.
Install ceiling hangers at conveyor splices as shown
below.
HANGER
UPRIGHT
(MIN. 1-1/2" X 1-1/2" X 3/16" ANGLE)
SP
LIC
E
DROP ROD
WELD NUT
(WELD AFTER LEVELING)
STOP
NUT
JAM
NUT
V-BRACKET
FLAT STRAP CONNECTOR
CROSS PIPE
EXTENSION NUT
(WELDED TO HANGER)
HANGER
Cross pipes, v-brackets, flat strap connectors, and
related hardware are provided standard. Drop rods
and hardware are optional.
CEILING HANGER SWAY BRACING
•
Sway bracing should be a minimum of 1-1/2”
x 1-1/2” x 3/16” angle.
•
Secure sway bracing to the hanger upright
near the conveyor and extend upward at an
angle between 30 and 45 degrees.
•
Brace horizontally to building structure
where possible.
•
Hanger uprights over 12’-0” long must have
a horizontal bridge as shown.
•
Sway bracing should be installed on every
third hanger or 30’-0”, whichever is less.
•
Install x-bracing as shown if bracing cannot
be installed outside uprights.
•
Additional bracing should be used before
and after curves, at drives, and at product
divert points.
BUILDING STRUCTURE.
WHERE POSSIBLE TO
HORIZONTAL BRACE
SWAY BRACES OVER 12' LONG
AT BRACE MIDPOINT TO
ADD HORIZONTAL MEMBER
SWAY
BRACE
COLUMN
HEADER
STEEL
UPRIGHT
HANGER
SWAYBRACE
X-BRACING
(1) BRACE EVERY SET OF HANGERS
ALTERNATE AS SHOWN
NOTE
Check for product clearance before
adding X-bracing.