MHS Boilers CRUZ belt, Инструкция по установке, эксплуатации и обслуживанию, Страница: 8 / 46

CRUZbelt
8
E0032544Rev090710
INTRODUCTION
This manual provides information for
installing, operating, and maintaining your
MHS Conveyor
CRUZbelt conveyor. A complete
parts list has been provided, along with a list of
recommended spare parts. Important safety
information is included throughout this manual.
MHS Conveyor
CRUZbelt is considerably
different than other belt conveyor. An
understanding of this manual will help you take
advantage of the many unique features of
CRUZbelt.
Some features of interest:
•
CRUZ
®
channel side frames have integrated
cable trays.
•
Side frames allow optional shrouds for a
sleek appearance.
•
Slider bed frames are interchangeable with
roller bed frames.
•
All intermediate bed sections can be made
into end beds.
•
End pulleys, snubbers, and take-up pulleys
are adjusted with cams. By eliminating the
usual threaded rods, adjustments are made
in seconds.
•
Innovative tube spanners eliminate bed
squaring.
•
Alignment sight holes allow all pulleys to be
easily squared before startup.
•
Motor mounting allows chain adjustment
without affecting sprocket alignment.
This manual is arranged in the suggested order of
installation.
RECEIVING AND UNPACKING
Check items received against the bill of lading or
packing list. Inspect all equipment for damage.
Claims for damaged equipment must be made
against the carrier immediately.
All units have an identification tag on them.
Important information on the tag includes model
description, item number, and tag number. The tag
number matches the tag number on the layout
drawing, if applicable.
SITE PREPARATION
1. Establish building baselines from the layout
drawings.
2. Lay out centerline and end points of each
unit using the building baselines.
3. Check the installation path for interferences.
FLOOR SUPPORT INFORMATION
All supports are intended to be used at a conveyor
splice or the end of a unit. If a splice cannot
be supported contact your
MHS Conveyor
distributor for other options. Support CRUZbelt at
each end and at every splice as shown below.
Leg elevations are shown on the elevation drawings.
Leg elevation can also be set by subtracting 6-3/8”
from the desired top of belt elevation.
NOTE
Top of Belt – 6 3/8”= Top of Support
If knee braces are required, they are installed on
approximately 30’ centers as shown below.
BRACE
KNEE
BRACE
STRAP
SUPPORT
FLOW
DOWNSTREAM
CENTER
DRIVE
Note brace direction. Near a drive the brace should
be on the upstream side of the support. Elsewhere
the brace should be downstream of the support. For
maximum effect the angle between the brace and
the side frame must be between 30 and 45 degrees.
Supports over 48” use a double knee brace. To
make a double knee brace, bolt two straps together
with a minimum 8” overlap.
WARNING
Leg uprights must be vertical.
Adjust stand head to compensate for slope.
SPLICE SPLICE
LAST LEG 6" FROM END