WG20 Instructions 5
WG20 consists of the devices shown in figure 2;
make immediately sure that they correspond to
the contents of the package and verify the
integrity of the devices.
Note: to adapt WG20 to local regulations, the
contents of the package may vary; an exact list
of the contents is shown on the outside of the
package under the "Mhousekit WG10 contains"
heading.
2.3
Description of Devices
A)
2 WG10 electromechanical gearmotors
complete with mounting brackets(*)
B)
3 release keys.
C)
1 pair of PH1 photocells (consisting of a TX
and an RX).
D)
2 TX4 radio transmitters.
E)
11 KS1 key-operated selector switch and
two keys.
F)
1 FL1 flashing light with incorporated aerial.
G)
1 CL20 control unit.
H)
Miscellaneous small parts: screws, screw
anchors, etc., see tables1, 2, 3, 4 and 5 (*).
(*) the screws needed to secure the front and
rear brackets are not supplied because their
type depends on the material and thickness of
the gate.
WG10 is an electromechanical gearmotor consisting of a worm screw
reduction gear and a 24Vdirect current motor. It features a key-operated
mechanical release mechanism that allows you to move the gate manu-
ally in the event of a power failure.
The gearmotor is fitted with four mounting brackets (two at the front and
two at the rear) and an adjustable stop (small plates that can be loos-
ened and adjusted on the teeth to limit the opening stroke) that offers
trouble-free installation in all conditions.
Table 1: list of small parts for two WG10 units
Q.ty
M10 self-locking nuts
2 pcs.
M8 self-locking nuts
8 pcs.
Front plates
2 pcs.
Rear plates
2 pcs.
Mounting brackets
8 pcs.
10x40 hex-head screws
2 pcs.
8x10 hex-head screws
2 pcs.
8x35 carriage screws
8 pcs.
8x24 flat washers
2 pcs.
8x16 flat washers
8 pcs.
2.3.1
WG10 Electromechanical Gearmotors
The three keys enable the gearmotor to be released in the event of a
power failure.
2.3.2
Release keys
Figure 3
Figure 2
Figure 4
B
C
D
E
G
H
F
A
