08
Transportation
1 - Shutdown engine for transportation.
2 - For transportation, tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
3. Drain fuel for transportation over long distance or bad road.
4. Secure machine firmly to prevent it from moving or tipping.
5. Rammer should be transported in such position as it is placed on level
ground.
6. Make sure lifting device has enough capacity to hold machine (see identifi-
cation plate on machine for weight). Use central lifting point when lifting
machine.
Rammer should be stored in such position as it is placed on level, after engine
and machine have been cooled down. Be sure to secure the rammer as
necessary to avoid falling down. If the rammer has to be laid down inevitably,
tighten fuel tank cap and engine oil plug securely and wait until engine and
machine are cooled down. After laying it down, make sure that there is no
leak of fuel or oil. (If fuel leaks, drain the tank).
Long-Term Storage
•
Drain fuel from fuel tank, fuel line and carburetor.
•
Remove spark plug and pour a few drops of motor oil into cylinder. Crank
engine 3 to 4 times so that oil reaches all internal parts.
•
Clean exterior with a cloth soaked in clean oil.
•
Store unit covered with plastic sheet in moisture free and dust free location
out of direct sunlight.
Cleaning
Cleaning the RAM 65H engine air filter (Honda GXR120 engine)
1 - Remove the two screws and the air filter cover. Then, remove the air filter
element (foam).
2 - Remove the paper air filter from the engine.
3 - Inspect the element and the paper air filter and inspect if necessary.
Replace the filters regularly according to the engine manufacturer's specifi-
cation (as per the engine instruction manual).
4 - Cleaning the air filters:
a) Air filter element: Clean with soap and water. Rinse and allow to dry
completely. Or, clean with non-flammable solvent and let it dry. Do not put
oil on that air filter element.
b) Air filter (paper): Tap the filter on a hard surface until all the dust comes
out. Or, use compressed air at a maximum pressure of 207kPa (2.1 kgf/cm or
30psi). Never brush the filter.
5 - Clean the dirt from the inside of the air filter box and cover it with a damp
cloth. Be careful to prevent dirt from entering the air duct leading to the
carburetor. After that, reassemble the air filter.
Storage
To
order
go
to
Discount-Equipment.com
