5 Maintenance
5 Maintenance
Use the gauge glass to check the oil level every time before start-up (please observe horizontal position). The oil level should be
half way up the gauge glass.
Check that the filter is clean every time before start-up!
Please ensure that the water is clean when taking in at outside locations. The hose cross-section must be at least ½“ =12.7 mm
The first oil change should take place after 500 operating hours. Further oil changes after 1000 operating hours in each case. Type
of oil: SAE20/30.
Warranty of any kind shall expire if the pump is operated without a universal safety valve or if the limiting values for temperature
and speed are exceeded ("Guidelines for fluid spray guns").
The safety valve must be set in such a way that the maximum operating pressure cannot be exceeded by more than 10%
For 905550 only:
Please note: Be sure to observe the information in the attached petrol motor instruction manual! The petrol motor should be
serviced and cared for in accordance with the manufacturer’s instructions. (or contact the S.A.T. Technical Assistance Service -
General Information section).
6 Repair
6 Repair
Both maintenance and repair must only be carried out by qualified and
MGF
MGF
approved personnel.
7 Disposal
7 Disposal
Components of the unit are recyclable material and should be put to recycling. For this purpose registered and certified recycling
companies are available. For an environmental friendly disposal of the non-recyclable parts (e.g. electronic waste) please contact
your local waste disposal authority. Oils and lubricants: Only specialist companies are authorized to dispose of old oils. Old oils and
contaminated oils must be stored and disposed of in sealed, oil-resistant containers (metal drums). Defective electrical appliances
and machines that cannot be repaired must be opened and cleaned to remove the remaining oil. Oil troughs must be cleaned so
that there are no traces of oil. No oils (even very small amounts) may be allowed to enter the ground!
Waste from maintenance work: Regulations issued by the responsible national and regional authorities for disposing of refuse must
be observed. These are available from the local environmental authority. If in doubt, waste from maintenance work such as
cleaning and rinsing agents, cloths etc. must be disposed of as special category waste by communal collecting points. Waste that
can be recycled must be separated on the basis of material groups and sent for suitable recycling! For EU countries only: Do not
dispose of electric tools with domestic waste. In accordance with European Directive 2012/19/EC on waste electrical and electronic
equipment and its implementation as national law, electric tools that are no longer serviceable must be collected separately and
utilised for environmentally compatible recycling.
10
MGF
MGF
srl –– Via Chico Mendes, 8 – 43058 Sorbolo Mezzani (PR) Italy – Tel. +39 0521-818301 Fax: +39 0521-818202
E-mail:
–
