The machines must not be positioned and operated in rooms subject to fire and explosion hazards or in puddles. The devices must
not be operated under water.
WATER SUPPLY CONNECTION
Use the hose clamp to fasten the water hose to the suction connection on the pump.
Please note: only use clean water! Do not supply dirty water, otherwise the pump gaskets will be damaged
Connect the water hose to the water supply and turn on the tap. The amount of water must be adequate for the respective high-
pressure cleaner type.
When drawing water in from a water tank, fasten the water intake hose and eliminate all air bubbles from water circuit
For best results, we suggest a inlet pressure around 1 bar, anyway water tank shall be at the same level of the pump.
Maximum allowed water temperature is 60°C
POWER SUPPLY CONNECTION
Plug the line cord plug into the socket (except on 905550).
Please observe the necessary fuse protection in accordance with the current consumption of the devices.
Power supply shall be equipped with a safety switch with a sensibility of 10mA
When using cable drums, be sure to unwind the cable completely!
MACHINE PREPARATION
Unroll the high pressure hose with nozzle loop-free and lead it into the pipe to be cleaned at least up to the marking. When using
the washing lance please connect this to the high-pressure hose by means of an adaptor.
Switch on the device or actuate the motor (with reference to article 905550, see the instructions for the internal combustion engine
supplied or contact the S.A.T. Technical Assistance Service - General Information section).
7
MGF
MGF
srl –– Via Chico Mendes, 8 – 43058 Sorbolo Mezzani (PR) Italy – Tel. +39 0521-818301 Fax: +39 0521-818202
E-mail:
–
