MGE UPS SYSTEMS
Pulsar ESV 8+
Rack
/11+
Rack
/14+
Rack
/22+
Rack
: 86-153523-00
19
overload
utility power present
operating anomalies
device fault
battery fault
Pulsar switches off automatically after
operating in overload for approximately 5
min.
no utility power present
Pulsar switches off automatically after a
length of time which depends on the level
of overload.
NOTE:
Overload occurs if the electricity
consumption of the load connected is
greater than the rated power of Pulsar.
To acknowledge the fault, push button
3
,
temporarily disconnected Pulsar from the
wall socket
5
, disconnect non-priority
loads and re-start Pulsar.
■
■
switch off Pulsar (push button
3
), dis-
connect from the wall socket (flex
5
), and
check that Pulsar has not short-circuited (dis-
connect all applications),
■
■
check the input fuse
6b
and replace it
with a fuse of the same rating or reset ther-
mal breaker 6 ,
■
■
re-start Pulsar.
A battery test is carried out while Pulsar, is in
start-up phase, then automatically every 7 days
(overhaul times adjustable using ESV Driver).
If a battery fault is detected, the following
occurs:
recharge your battery for 8 hours.
If battery fault persists, see next page.
utility power outside limits
continuous
beep
after the start-up sequence, if the audio
warning device sounds continuously, check
the voltage and frequency of your utility
power (see the § entitled "characteristics")
and/or recharge your battery for 8 hours.
Start/Stop control on output
receptacles 1 and 2
(PowerShare)
You can use the applications included on
the CD-ROM to remote control the
Start/Stop sequences on output receptacles
7a
(or
7b
). If
7a
(or
7b
) is disabled
through software, front panel led
1f
(or
1e
) flashes, with 1 beep every second.
Beep can be deactivated by
"function" button 2 .
NOTE:
If the previous symptoms persist, contact
our after sales department.
1 beep
every
second
1 beep
every
second
1 beep
every
second
1 beep
every
second
…
