3
If you are preparing for an event and want maximum battery power
available, you can "run down" your pack and fully recharge it in
advance. Connect a 5-Watt 50-Ohm resistor (or dummy load) and a
voltmeter to the MFJ-4114 terminals. Draw pack down to 11 Volts ( 5 0
Ohms = 300 mA/Hr discharge rate). Then fully recharge.
FIGURE 1, INSTALLING BATTERIES IN YOUR MFJ-4114:
INSTRUCTIONS: Remove 8 screws around bottom sides o f cover.
Lift cover as shown above. Install 12 NiCd batteries according to
polarity markings inside the battery holders. I f a battery holder
becomes unplugged from the pc board header while loading, you may
reinstall the plug either way without damage: Center pins are (-),
outside pins are (+).
SCHEMATIC DIAGRAM, MFJ-4114 RECHARGING POWER PACK:
WARNING: DO NOT TRY TO RECHARGE CARBON-ZINC OR ALKALINE CELLS IN YOUR
MFJ-4114. NEVER SHORT-CIRCUIT, PUNCTURE, OR INCINERATE BATTERIES --
JACKETS MAY EXPLODE OR LEAK TOXIC MATERIALS. PLEASE DISCARD USED
BATTERIES IN ACCORDANCE WITH SUPPLIED INSTRUCTIONS.
Содержание MFJ-4114
Страница 3: ...3...
