1. Never store unused material in spreader. Return
unused product to its original container.
2. Wash spreader thoroughly after each use and dry
completely in sun or heated area.
3. Oil the axle bearings, impeller shaft bearing in
hopper, control knob in
T-handle.
4. Remove gear cover and wash gears thoroughly.
Oil all bearing areas and face of gear teeth. Re-
install gear cover.
5. Gear mesh should be checked on a regular basis
during high use periods. Clearance between the
axle gear and pinion gear should be minimal but not
tight. If adjustment is necessary, loosen axle collar
set screw and hold gears together. Slide axle collar
against the gear support and tighten axle collar set
screw. Spin drive wheel. Gears should run freely
and smoothly.
6. Impeller surface should be cleaned periodically to
remove build-up of product. Build-up can cause the
spread pattern to change.
7. Tire pressure should be 20-25 PSI.
MAINTENANCE
Oil
Oil Impeller Shaft
Bearing In Hopper
Axle Collar
Oil
Oil
Oil
Meyer Products warrants to Purchaser the following:
Meyer Products, Inc., warrants to the original purchaser for a period of one year from the date of purchase of Meyer® and Diamond® brand spreader
products that they will be free from defects in materials or workmanship, with the exceptions stated below. No person is authorized to change this warranty
or to create any additional warranty on Meyer®/Diamond® products.
Meyer Products will repair any product that proves to be defective in materials or workmanship. In the event repair is not possible or practical (as deter-
mined by Meyer Products in its sole discretion), Meyer Products will either replace the product with a new product of similar model and price, or refund the
full purchase price, as determined by Meyer Products. Customer must keep the complete spreader system serviced/maintained as recommended by
Meyer Products.
This warranty does not cover:
• Problems caused by failure to follow the product instructions, or failure to maintain the product as described in the Operator’s Manual;
• Damage resulting from rust, corrosion
• Damage caused by usage that is not in accordance with product instructions (use of the spreader for any purpose other than spreading approved mate-
rial is considered misuse and abuse);
• Any spreader, or any part, component, or assembly thereof, which has been modified or altered;
• Problems caused by using accessories, parts, or components not supplied by Meyer Products;
• Cost of tax, freight, transportation or storage charges, environmental charges, solvents, sealants, lubricants or any other normal shop supplies.
• Problems caused by collision, fire, theft, vandalism, riot, explosion, lightning, earthquake, windstorm, hail, water, flood, or any other Acts of God;
• Liability for damage to property, or injury to, or death of any person arising out of the operation, maintenance or use of the covered product;
• Products with missing or altered serial numbers;
How To Get Service:
• It is the responsibility of the original purchaser to establish the warranty period by verifying the original delivery date. A bill of sale, cancelled check or
some other appropriate payment record may be kept for that purpose. It is recommended, but not required, that the consumer verify the original delivery
date by immediately returning the attached Warranty Registration Card.
How State Law Applies:
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
WARRANTY
