OPERATION
1.
Check the product package for the rate
setting, and recommended swath width. Turn the
spreader OFF by pushing the control knob in.
3.
Always fill the spreader on the driveway or
sidewalk-not on the lawn. Make sure spreader is
in the “OFF” position
.
Empty after each use.
4.
Start spreader moving, then open spreader by
pushing the thumb release to the “ON” position.
Always push spreader, never pull. Push knob
down to close spreader.
5.
Hold handle so top of spreader is level. Tipping
the spreader too far can cause uneven spreading.
6.
The settings and swath widths on the product
label are recommended starting points. Always
check the delivery rate and pattern on a small area
before treating a large area. Actual delivery rate can
vary due to weather conditions, operating variables,
and condition of the product being applied. See
“HOW TO DETERMINE SPREADER SETTING AND
SWATH WIDTH” for details.
7.
Push spreader 2 1/2 m.p.h. (18 feet in 5
seconds) for full 8’ to 14’ spread pattern when
applying fertilizer products. Apply header strips
at each end of area to be treated then space trips
across the area as shown.
8.
Empty spreader after each use. Return
leftover material to its original container.
2.
The rate setting is adjusted by rotating the
rate cam to the desired setting. The rate cam
locks at each setting.
SPREAD SWATH
APPROX. 8 to 14
FEET ON CENTER
NOTE: This spreader is equipped with a factory installed deflector shield that is used for applying
ice melt to narrow areas. Shield is easily removed when ice melt is apply to large areas or when
using turf care products
.