Metz mecablitz 64 AF-1 digital, Руководство по эксплуатации

Страница: 1142 / 1614

180
Setting the flash frequency (f(Hz))
• Press the sensor button on the touch
display for the flash frequency .
• Press the sensor buttons on the
touch display and select the desired fre-
quency of flashes.
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired frequency of flashes
in the example
.
The setting will take effect immediately.
The valid distance to the set parameters is
shown on the display. The distance value dis-
played can be adjusted to the distance from
the subject by changing the f-stop or the par-
tial light output.
The aperture and ISO values are not shown
on the display in Strobe flash mode!
The secondary reflector is not supported in
the Stroboscopic flash mode.
8
f (Hz)
7.7 SPOTBEAM mode
In the SPOTBEAM mode, the AF measuring
beam can be used to focus on a subject at
low ambient light level without firing a flash
when the shot is taken.
There is no flash-ready indicator in
SPOTBEAM mode and no exposure control
indicator in the camera viewfinder. The came-
ra is not set to its sync speed and behaves as
though there were no flash unit connected.
SpotBeam mode is only activated when the
flash unit is switched on and is flash-ready
(check the flash-ready indicator on the flash
unit!).
When the camera shutter is released, no
flash is fired. Please read the notes on the AF
measuring beam in chapter 11.8 AF-BEAM.
f (Hz)
q
p
7
8
9
2,2m
M-
Zoom
35
m
m
STROBO
i
P
1/16
f(Hz)
10
N
4
2,2m
M-
Zoom
35 m
m
STROBO
i
P
1/16
f(Hz)
8
N
4
+
+
+
k