72
ķ
The flash unit can be rotated (turned)
on the adapter ring.
Removal
Press both the release buttons
on
the flash unit, keep them pressed, and
at the same time carefully pull the
flash unit off the adapter ring of the
objective.
2.4 Switching the flash unit on
and off
To switch-on, move the main switch
to the “ON” position. To switch-off,
move the main switch to the left.
If the flash unit is not required for a
longer period of time, it should
always be switched off by the main
switch and the batteries/rechargea-
ble batteries should be removed from
the flash unit!
2.5 The infrared clamp
The camera’s own flash unit and the
use of mecablitz 15MS-1 digital
should not contribute to the lighting of
macropictures, so that no shadows
are caused by the housing of meca-
blitz 15MS-1 digital.
The camera’s own flash light can be
covered with the infrared clamp. The
infrared clamp allows the control
impulses through, but holds back the
flash light, which contributes to the
lighting.
Installation of the infrared clamp
Open the infrared clamp with your
fingers and slip it over the camera’s
own flash unit.
Slide down the infrared clamp with
rubber lips as far as possible over the
camera’s own flash unit and close it.
☞
708 47 0018.A3 15 MS-1 01.04.2010 9:56 Uhr Seite 72
