79
ķ
5.2 Slave mode
“Slave mode” reflects the setting that
has been learnt in the “Learn func-
tion”. This function is retained until a
“Learn function” or a “RESET” is per-
formed again.
Adjustment of the flash unit
• Activate the camera flash unit.
• Slide the infrared clamp over the
camera’s own flash unit if it is to be
used as controller flash unit. Swivel
external flash unit so that it cannot
contribute to lighting.
• Switch-on flash unit with the main
switch
.
• Keep the button “AF/SELECT”
on
the flash unit pressed until the follo-
wing message appears in the
display:
• Press the button
on the flash
unit. In the display appears:
S E L
• Press the button
on the flash
unit. The most recently used setting
appears in the display, e.g.:
• Press the button
until “SYSTEM
SLAVE” appears in the display.
• Press the
button and the SLAVE
mode is set with a ratio of 1:1 bet-
ween both the reflectors and full
lighting power (Power) 1/1.
Following display appears:
• If both reflectors should be set at an
unequal ratio (
R
atio) then press the
button
or
to change the ratio.
The ratio can be adjusted in steps. In
the display appears, for example
• If you wish to use partial lighting,
then press the button
.
Following display appears:
• To set partial lighting, press the but-
tons
or
and thus change the
value. In the display appears, for
example.
The setting thus made will be automa-
tically saved.
P / R
OK
S E L
S E L
S E L E C T
⊃
S E L
OK
M O D E L L I N G
L I G H T
O F F
O N
15MS-1
V 1 . 0
S E L
OK
SYSTEM
NIK
REMOTE
Ch ALL Gr A
S E L
OK
SYSTEM
S L AV E
1:1
P / R
SL
R
atio
4:1
P / R
SL
R
atio
1/1
P / R
SL
P
ower
1/4
P / R
SL
P
ower
708 47 0018.A3 15 MS-1 01.04.2010 9:56 Uhr Seite 79
