All-Engineering BV
https://metrumacoustics.com
[email protected]
•
XLR outputs
: Standard XLR line cables should be used to connect the DAC to your (pre)
amplifier. The "PAVANE" is designed conform the "Red book standard" so the maximum
output for the XLR output will be 4 Volts RMS or 11.4 Volts peak to peak. Your (pre)amplifier
should handle this output level.
•
Mains supply:
First check the marks on the backside of the "PAVANE" to be sure it matches
the power requirements for the specific country.
•
Mains inlet:
Use the supplied power cable to a grounded power outlet.
Operation
•
On/Standby switch:
To reduce power the DAC boards will be switched off in stand-by mode.
Just the front panel is activated to control the system and power consumption will be
reduced to 1.5 Watts.
•
Mute function:
By powering up the DAC the mute function will be activated for five seconds.
When switching the DAC to standby mode muting will be active again.
•
Source selection:
The digital inputs can be selected by using five small buttons on the front.
When switching the DAC on, by default the last selected source will be active.
•
Error indication:
When no digital data is coming in, the orange Remote /Error led above the
remote sensor will burn.
•
Remote indication:
When using the remote control the Remote/ Error led will flash rapidly.
