Metronic 450908, Руководство по установке, Страница: 8 / 28

Prepare the motor (see diagram 2)
Assembling
• Make sure the fixing (tube or stand off arm) is stabilised
and strictly vertical. A gap of more than 1 degree (2 cm,
0,78” per meter) from the vertical will prevent the motor
to work correctly. In case, add some block between the
wall and the fixing. Check the verticality with a spirit
level or a plumb line.
Warning: When you will screw the screw 2C (which
must not be blocked), a too important tightening might
break one of the support clamps.
When the motor is assemble, do not fix it straight away
on the mast or the stand off arm, some operations needs
to be done near the receiver.
• Screw on all the screw without blocking it. The screw 2b
must be tighten at the maximum and the cover 2a must
be leave up to allow you to read the motor angle in rela-
tion to south.
WARNING: the screw 2b must get in by the small hole
in the bend mast and the nut must be tighten on the big
hole side, with the rounded nut moulded the curves of
the big hole.
C
6
0 208 994 11 81