Metrologic MS2020 Stratos, Руководство по обслуживанию

Страница: 47 / 102

39
©2004 Metrologic Instruments, Inc. All rights reserved MS2020 Stratos Service Manual
SERVICING AND MAINTENANCE PROCEDURES
HORIZONTAL SCAN MODULE - REMOVAL
Removal Instructions:
1. Remove platter tray and carefully set a
side in a safe location. (Refer to
Removal Instructions located on page
29 of this manual)
2. Remove Stratos Scanner chassis from
counter. (Refer to Removal Instructions
Section.)
3. Carefully turn Stratos Scanner unit
upside-down and locate the 4 TORX
Screws keeping the Horizontal Scanner
Module in place. (Refer to Figure to the
right.)
4. Using a size T-10 torx screwdriver,
remove all 4 torx screws noted in step 3.
5. Carefully grip Horizontal Scanner
Module with both hands one both left
and right sides of Module. (Refer to
Figure to right.)
6. With a gentle pulling motion, module
should easily lift out of Stratos chassis.
7.
Place old Horizontal Scan Module aside
and follow Vertical Scan Module –
Installing procedure.
Horizontal
Scan Module
Safe Lift
Areas!
Torx Screws holding
Horizontal Scan