Metrohm 867 pH Module, Руководство пользователя

Страница: 27 / 49

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
867 pH Module
￭￭￭￭￭￭￭￭
19
3.4.2 Connecting a USB hub
If you wish to connect more than two devices to the USB connector of the
867 pH Module, you can also use an additional commercially available
USB hub (distributor). If you operate the 867 pH Module with the help of
the Touch Control, then you should use a USB hub with its own power
supply.
Connect the USB hub as follows:
1 Switch off the Touch Control and/or exit the PC software.
2 With the aid of the 6.2151.020 cable, connect the USB connector of
the 867 pH Module (type A) with the USB connector of the hub (type
B, see manual for the hub).
3 Switch on the Touch Control.
The USB hub is recognized automatically.
3.4.3 Connecting a printer
Printers that are connected to the 867 pH Module with Touch Control
must meet the following requirements:
￭
Printer languages: HP-PCL (PCL 3 to 5, PCL 3GUI), Canon BJL Com-
mands or Epson ESC P/2
￭
Printer resolution: 300 dots/inch or 360 dots/inch (Epson)
￭
Paper size: A4 or Letter, single-sheet feed.
Connect the printer as follows:
1 Switch off the Touch Control.
2 With the aid of the 6.2151.020 cable, connect the USB connector of
the 867 pH Module (type A) with the USB connector of the printer
(type B, see manual for the printer).
3 Switch on the printer first, then the Touch Control.
4 Configure the printer in the device manager of the Touch Control
(see Touch Control manual).