4
Assembling the fireplace insert’s firebox
The fireplace insert firebox is supplied in a heavy duty
carton and is secured to a timber pallet. Having removed
the cardboard, timber and polystyrene packaging and
familiarised yourself with Diagram 1 on page 2, proceed
as follows: -
• Remove from within the firebox the plastic bag
containing the bolt kit, two firebricks wrapped in a
cardboard wrapper and the top baffle assembly.
• A “spacer” washer has been pre-fitted and taped to
the top door hinge pin on the left hand side of the
firebox (Refer Inset A, Diagram 1) remove this tape.
• Take the boxed door you previously removed from the
centre of the fascia and unpack it. Taking the door in
both hands with the spindle end in your right hand and
outer face of the door facing you, attach the door to
the firebox as follows: -
- With the door in a 45 degrees open position, allow the
lower hinge pin on the bottom left hand side of the
firebox to pass into the hole provided in the bottom of
the door frame.
- Lift the door until the top of the door frame passes over
the top hinge pin, then align the hole provided on the
top face of the door frame and lower it down over the
top hinge pin.
- Take the door handle from the plastic bag and screw it
onto the door spindle by turning it clockwise.
• Unwrap the two firebricks from the cardboard wrapper
and fit the side bricks to each side of the firebox.
Location lugs are fitted to the base and rear of the
firebox to retain the side bricks in position, refer
Diagram 3 on the opposing page.
• Remove the “cabinet top” which is packed inverted
on top of the firebox and fit it into position “over” the
cabinet sides as detailed in Diagram 1. Ensure the rear
edge is fitted correctly as shown in Diagram 1, Inset
“B”. The rear edge of the cabinet top must fit “into” the
slot provided. Using two of the self tapping screws from
the plastic bag, secure the cabinet top in place. Note,
this panel can be fitted at two height’s, if the height of
the fireplace opening will allow, fit the cabinet top in
the higher position, fit screws from “inside” the cabinet
facing out.
• Ensure the insulating blanket is in position on the top of
the cabinet.
• Remove the four speed clip nuts from the plastic bag
and fit them to the holes provided in the front edge of
the cabinet as shown in Diagram 1.
• Next you need to fit the top baffle, refer to Diagram
3 on the opposing page 5 and proceed with the
instructions below that apply to the model you are
assembling: -
LTD Insert Firebox
This model has a two piece top baffle which locates onto
six lugs provided on the side walls of the firebox’s upper
chamber, as detailed in Diagram 3 on page 5. The rear
baffle section is 6mm folded steel and has a location pin
fitted to its front top surface. Fit this rear baffle through the
door opening and into position in the upper chamber of
the firebox. It is supported on the rear four support lugs
and must be hard back against the rear of the firebox with
the locating pin facing upward and towards the front.
Next, locate the front baffle which is a combination baffle
comprising of a 6mm steel plate with a promet (white
board) front extension. Fit this baffle through the door
opening and into position, ensuring the hole provided on
its rear edge is positioned over the locating pin fitted to the
rear baffle.
Содержание LTD Insert
Страница 16: ...16...
