INSTALLATION & SET-UP
10
3. 4 Optional rackmounting
Rackmounting kits may be used to mount two LV2000 units side by side in a 19” rack.
The kit, Part no 80-05-256, has a recessed plate to permit cable or fibre bends to be made
within the envelope of a 19” rack. It also has a single cut-out for all connections to the rear
of the LV2000. The installation method is the same in all cases.
First remove the two rear panel screws securing each unit’s lid. Fasten the two LV2000 units
to the rackmount adaptor plate using the screws that you have removed, as shown in the
illustrations below.
Then secure the rack mounting plate complete with the two LV2000 units to the 19” rack
using the locating holes at the ends of the adaptor plate. If you have set the bit-switches on
the base plate of the units before fixing them to the adaptor plate, check that the settings are
still correct.
Figure 3. 3 2-unit recessed rackmounting plan & elevation
Recessed space to accommodate cable bends
LV2000
LV2000
SUBSCRIBER PORT
10/100 BASE T
LINK/ACT SPEED
Made in
UK
Tx Rx
DTE Activity
(CRY PTO RE D)
SUBSCRIBER PORT
10/100 BASE T
LINK/ACT SPEED
Pin1
-48V
Pin3
0V
L
__
Made in
UK
Tx Rx
DTE Activity
(CRYPTO RED)
