METRO PROFESSIONAL GSC2350, Инструкция пользователя

Страница: 7 / 197

- 7 -
GB
Problem
Possible
cause
Solution
Appliance
does not
achieve
required
temperature.
Thermostat
is not set
correctly.
Set temperature
with thermostat as
described in this
manual.
Appliance is
located near
heat sources.
Move appliance
well away from heat
sources.
Stored
beverages or
other objects
prevent
proper closing
of door.
Reorder contents
of cooling
compartment or
remove several
items to allow door
to close.
Cooling
compartment
overloaded,
filled with hot
beverages or
filled in a way
that prevents
proper air
circulation.
Remove several
items, remove
hot beverages or
reorder contents
of cooling
compartment to
allow air circulation.
Door opened
and closed
too often.
Keep door closed
for a while.
Appliance is
very noisy.
Back of
appliance is
placed too
near to the
wall or to
other objects.
Keep a minimum
distance of >10cm
to wall or other
objects.
Appliance not
in a stable
position.
Bring appliance into
a stable position by
adjusting the legs.
Make sure that all
legs are firmly on
the ground.
Condensation
on outside of
appliance.
Normal
phenomenon
in hot and
humid
environments.
Wipe appliance with
a dry and soft cloth.
For the circuit diagram , please see illustration at the
end of this manual.
a. Switch
b. LED power
c. LED lamp
d. Thermostat
e. Evaporator fan motor
f. Overload protector
g. Compressor
• To ensure a trouble-free performance and to
avoid excessive electricity consumption, clean
the condenser every three months using a
vacuum hose. When using the appliance under
special conditions, clean the condenser more
often. Clean the condenser coil in the same way
at least once per year. If the condenser coil is
not cleaned at least once per year, the efficiency
of the appliance will decrease significantly.
• Clean the gaskets and seals with a dry and soft
cloth. Check them for debris to ensure the door
always close properly.
• The appliance may only be used again or stored
after it is dried completely.
Defrosting
• To defrost the appliance, remove all foodstuffs
from it, set the thermostat to “OFF” and unplug
the appliance.
• Let the ice in the appliance interior melt and
discard the water afterwards.
Storage
• Before storing, remove all foodstuffs from
the appliance, disconnect it from the supply
and clean the appliance and its accessories
thoroughly.
• Store the appliance in a dry, protected
environment, preferably at room temperature.
• To protect the appliance from dust, cover it
with a cloth that allows air circulation inside the
appliance.
4. Troubleshooting
WARNING!
• In case of failures or malfunctions, always
unplug the appliance immediately.
• Only perform the steps described in this
instruction manual! All further inspection,
maintenance and repair work must be
performed by an authorized service center or a
similarly qualified specialist.
• Should you require spare parts, always obtain
them from an authorized seller. Do not use
spare parts that are not recommended by the
manufacturer!
Problem
Possible
cause
Solution
Appliance
does not
operate.
Power plug
not connected
to electrical
outlet.
Connect power
plug to a suitable
electrical outlet.
Plug it in tightly.
Supply cord is
damaged.
Have supply cord
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.