Metra Electronics Metra Electronic Lock, Руководство по установке

Страница: 8 / 23

6
8. The Flat six cable needs to be cut to the desired length.
(approx. 100mm excess at the Lock for maintenance purposes and 500-1000mm at the control cabinet)
i.e. The cable lengths can be calculated by:
[
Depth of c 100mm (extra cable for lock)] + [Distance to centre of Control c 500-1000mm] = Total.
* Note: The cable lengths may need to be increased for the Top and Bottom lockers to account for slightly longer
lengths of cable required, as they should be bundled at the centre locker in the Locker carcass.
9. The flat cable should be inserted into the connector so that the RED stripe is aligned to the
Triangle marked on the connector and the RED line marked on the Metra 16x6 Crimp tool as shown below.
Make sure the cable is perpendicular to the cable and not on an angle.
10. Now squeeze the Metra crimp tool’s handle to crimp the flat ribbon cable to the connector.
– A click should be heard.
11. Once the flat ribbon cable has been successfully crimped to the connector, trim off the excess cable with a knife
or cutters.
– Take necessary safety precautions and use appropriate PPE if using a knife to trim the cable.