99-9613
®
11
Handlebar Control Settings
(Cont)
Dual Assignment (long button press)
The ASWC-1 has the capability to assign two functions to a single button,
except Volume-Up and Volume-Down. Follow the steps below to program the
button(s) to your liking.
Note:
Seek-Up and Seek-Down come programmed as Preset-Up and Preset-
Down for a long button press.
1.
Turn on the ignition but do not start the vehicle.
2.
Press and hold down the handlebar control button that you want to assign a
long press function to, for ten seconds, or until the L.E.D. flashes rapidly. At this
point release the button; the L.E.D. will then go solid.
3.
Press and release the Volume-Up button the number of times corresponding
to the new button number selected. Refer to the Dual Assignment Legend. The
L.E.D. will flash rapidly while the Volume-Up button is being pressed, and then
go back to a solid L.E.D. once released. Go to the next step once the Volume-Up
button has been pressed the desired number of times.
Caution:
If more than ten seconds elapses between pressing the Volume-Up
button, this process will abort, and the L.E.D. will go out.
4.
To store the long press button in memory, press the button that you assigned a
long press button to (the button held down in Step 2). The L.E.D. will now go off
indicating the new information has been stored.
Note:
These steps must be repeated for each button you would like to assign a
dual purpose feature to. To reset a button back to its default state, repeat Step
1, and then press the Volume-Down button. The L.E.D. will go off, and the long
press mapping for that button will be erased.
* Not applicable in this application
Dual assignment legend
1
- Not allowed
2
- Not allowed
3
- Seek-Up/Next
4
- Seek-Down/Prev
5
- Mode/Source
6
- ATT/Mute
7
- Preset-Up
8
- Preset-Down
9
- Power
10
- Band
11
- Play/Enter
12
- PTT
13
- On-Hook
14
- Off-Hook
15
- Fan-Up
16
- Fan-Down *
17
- Temp-Up *
18
- Temp-Down *
