REV. 11/14/2018 INST99-7382HG
7
FINAL ASSEMBLY
PROGRAMMING THE ASWC-1 AND
CLIMATE DISPLAY
1.
Secure the radio assembly to the dash using the factory screws.
2.
Secure the
radio trim panel with climate display and hazard switch
to the dash using the
factory screws.
3.
Reassemble the dash in reverse order of disassembly to complete the installation.
Programming the ASWC-1:
1.
Press and hold the
Volume-Up
button on the steering wheel, then turn the ignition on. The L.E.D.
will start flashing rapidly, which means the
ASWC-1
is looking for the vehicle and the radio.
Note:
If the L.E.D. didn’t start flashing rapidly, press the reset button for 3 seconds, while
still holding the
Volume-Up
button.
2.
After a few seconds the L.E.D. should stop flashing rapidly, then go out for approx. 2 seconds.
3.
After approximately 2 seconds there will be a series of 7
Green
flashes, some short, and
some long. The long flashes represent the wires that are connected to the
ASWC-1
.
Tip:
Knowing this will help to troubleshoot, if need be.
4.
The L.E.D. will pause for another 2 seconds, then flash
Red
up to 18 times depending on
which radio is connected to the
ASWC-1
. Refer to the L.E.D. feedback section for information.
5.
This is the end of the auto detection stage. If the ASWC-1 detected the vehicle and the radio
successfully, the L.E.D. will light up solid. Release from holding the
Volume-Up
button.
6.
Test the steering wheel controls for proper operation. Refer to
(ASWC-1) Steering Wheel
Control Settings
for customizing the buttons, if so desired.
Programming the climate display:
7.
Turn the key (or push to start button) to the ignition position if not already.
8.
Press the hazard button.
9.
In a few moments both the smaller LCD screens on the climate display should illuminate.
10.
Test all functions of the installation for proper operation, before reassembling the dash.
