1.800.221.0932
|
MetraOnline.com
6
3.5mm jack steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
•
For the radios listed below:
Connect the
female 3.5mm connector with stripped leads
, to the male
3.5mm SWC jack from the wiring harness included with the kit. Any remaining wires tape off
and disregard.
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/White
wire from the connector. Then connect the remaining steering wheel control wire,
normally
Brown/White
, to the
Brown
wire from the connector.
•
Metra OE:
Connect the steering wheel control Key 1 wire
(Gray)
to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/Yellow
wire to the
Brown
wire.
Note:
If the
Kenwood
radio auto detects as a JVC, manually set the radio type to
Kenwood
. See the instructions under
Changing Radio Type
.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack to the AX-SWC-PARROT (sold
separately). Then connect the 4-pin connector from the AX-SWC-PARROT to the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the
Brown
wire from the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire
from the connector. If the radio comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information
.
•
For all other radios:
Connect the 3.5mm jack from the wiring harness included with the kit
to the jack on the radio designated for an external steering wheel control interface. Refer to
the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
CONNECTIONS
(CONT.)
INSTALLATION
With the key in the off position:
1.
Connect the wiring harness included with the kit to the
radio trim panel with climate display
and hazard switch
, and then to the wiring harness in the vehicle.
2.
Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
3.
Connect the wiring harness included with the kit to the ASWC-1.
Attention!
If retaining steering wheel controls, ensure that the SWC jack/wire is connected to the
radio before proceeding. If this step is skipped, the interface will need to be reset for the steering
wheel controls to function.
