10
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to
as Key-A or SWC-1, to the
Brown
wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire
of the connector. If the radio comes with a third wire for ground, disregard this wire
.
Note:
After the interface has been programmed to the vehicle, refer to the
manual provided with the radio for assigning the SWC buttons. Contact the
radio manufacturer for more information.
• For all other radios:
Connect the 3.5mm jack into the port on the radio designated
for an external steering wheel control interface. Refer to the manual provided
with the radio if in doubt as to where the 3.5mm jack goes to.
4-pin harness with yellow RCA jacks:
This harness is to be used to add an aftermarket backup camera to the
touchscreen display
,
if so desired.
• Connect the
Yellow
RCA jack labeled “Rearview camera”, to the RCA jack on the aftermarket
backup camera.
Note:
If this method is chosen, the backup camera option must be enabled in the
Configuration Settings Screen.
• Disregard the
Yellow
RCA jack labeled “AUX video”, it will not be used in this application.
3.5mm jack steering wheel control retention:
• The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• For the radios listed below, connect the included
female 3.5mm connector with
stripped leads
onto the male 3.5mm SWC jack. Any remaining wires tape off and
disregard:
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/
White
wire of the connector. Then connect the remaining steering wheel control
wire, normally
Brown/White
, to the
Brown
wire of the connector
.
•
Metra OE:
Connect the steering wheel control Key 1 wire
(Gray)
to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/
Yellow
wire to the
Brown
wire.
Note:
If your Kenwood radio auto detects as a JVC, manually set the radio type
to Kenwood. See the instructions under changing radio type.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the AX-SWC-PARROT
(sold separately), and then connect the 4-pin connector from the AX-SWC-PARROT
into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
CONNECTIONS TO BE MADE
(CONT.)
