Metos IND-10P-3500, Инструкция по установке и эксплуатации

Страница: 19 / 32

|
5
19.3.2015
Metos Eco Kitchen
Code Possible Cause Correcting Measure
E4 (04) Pan temperature too high, caus-
ing the equipment to stop work-
ing.
• Check if the unit occurred dry-heating.
• Check if the cooling fan of the coils works properly.
• Oil temperature in the pan too high. Lower the
power level.
E5 (05) Damage of power potentiome-
ter, or the power level is not set
at the “0” position.
• Set the power level not set at “0”position before use.
• Problem of the power control. Check of replace-
ment needed.
E6 (06) Power module temperature ris-
es too fast.
• Check if the fan is running.
• Consult professional personnel
E7 (07) Error of temperature sensor of
the power module.
• Consult professional personnel
E8 (08) Temperature of power module
too high and the generator is
working with reduced power.
• See E3
E9 (09) Error of pan temperature sensor. • Consult professional personnel.
EA (10) The voltage of power supply is
lower than 340V.
• Ensure proper voltage.
• Ensure proper wiring.
• Consult professional personnel
- Reserve
EC (12) Over temperature of coils, the
generator stops working.
• Consult professional personnel
ED (13) Error of Coil temperature sen-
sor.
• Consult professional personnel
- Reserve
EF (15) Surge protection • If this does not happen frequently, ignore it, be-
cause automatic restart will be effected.
• If this happens frequently, Consult professional
personnel
E (16) Hard protection of driving board. • Consult professional personnel
EP (17) Error of Hall sensor • Consult professional personnel
Mahdolliset virheet:
Fault Possible Cause Correcting Measure
There is no heating, lamp or indi-
cator is blinking
Error occurs. Check the Error code list and fol-
low the instructions.
There is no heating, lamp or in-
dicator is off
No power supply Check whether the power cord
is well connected.
PCB/ Components are Broken Consult professional personnel
Heating effect is good but indi-
cator or lamp is off.
Lamp or Indicator is broken. Consult professional personnel
Switch does not work or the
power could not be adjusted by
rotating/sliding Switch.
Switch failure; Consult professional personnel