Metos EMS 6 INOX M1, Инструкция по установке и эксплуатации, Страница: 5 / 16

|
5
8.5.2015
Metos EMS
5.4. Leveling
Its extremely important that the cabinet is perfectly level for proper operation so that the drain pan will
drain properly, the doors will line up with the frames and the unit will not be subject to undue strain.
These models are supplied with non-adjustable casters allowing easy cleaning of the floor under the unit.
In this case, just ensure the floor where the unit is located is level. To operate in a stable condition, the
front casters must be locked.
Adjustable legs in lieu of casters are supplied as an optional accessory for all our models. In case you
install legs, you should adjust them until the unit is stable and completely level.
5.5. Initial cleaning procedure
Before starting-up and placing any food inside the cabinet, firstly re-
move the protective film and then clean the complete unit thorough-
ly. If any adhesive remains, eliminate it with alcohol. Washing with a
mild soap and warm water solution is recommended for cleaning all
the stainless steel surfaces of your
cabinet. This should be followed by cleaning with a baking soda so-
lution. Rinse thoroughly with clear water and dry with a clean, soft
cloth.
Never use abrasive or harsh cleaners, concentrated detergents, solvents or chemicals when cleaning
the unit.
6. ELECTRICAL INSTRUCTIONS
The supply voltage should be checked before connection to assure that proper voltage for the cabinet
wiring is available. To determine correct unit voltage, please refer to the serial data plate located on an
inner wall of the unit. Verify that this information exactly matches the electrical characteristics at the
installation location.
The manufacturer requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
The unit is designed to operate with a voltage fluctuation of 5% of the voltage indicated on the cabinet
serial data plate. Burnout of the compressor due to exceeding the high or low voltage limits will automa-
tically void the factory warranty.
Any alterations to this cord and plug could cause an electrical hazard and will void the factory warranty.
Furthermore, never use an adapter plug.
The manufacturer will not warranty any units that are connected to an extension cord.
7. STARTUP PROCEDURE
After the cabinet has been installed, levelled, cleaned and electrically connected in accordance with this
manual, it is ready to operate. Simply plug the unit in to begin operation.
The system should run smoothly and quietly in accordance with generally accepted commercial stan-
dards. If any unusual noises are heard, turn the unit off immediately and check for any obstructions of
the fans.
All cabinets must be given enough time to reach normal operating temperature before placing any food
inside cabinet or pans (if equipped). Continuous opening and closing of the doors will hamper the unit’s
ability to maintain optimum refrigeration performance.