|
13
Rev. 5.0 (from 01.08.2011)
Metos ARDOX S
Ardox S2 Solid Top Cooking Unit
The supply cable inlet is in the back right-hand corner of the range and the connection point inside the range.
The top deck needs to be opened to connect the range to the mains. Raise the deck up.
Be cautious when opening the deck because of its weight and always lock the deck into the open
position with the fi xing rod.
In case of combination of a range and an oven, the connection point for the supply cable is located on
the rear wall of the oven (right low corner). In order to make the connection, the right side panel of the
oven must be removed.
Ardox S Tabletop
The Tabletop is equipped with a cable with with a plug. The length of the cable with plugs is 2000 mm.
Ardox S Drop-In
Appliance is delivered with completely made internal wiring. To switch appliance on just connect supply
cable to the connection terminals.
Mounting bracket with connection terminals is placed temporary inside electrical compartment of the hob.
Mounting bracket with connection terminals must be fi xed outside electrical compartment in proper
place before supply cable is connected.
Spisens The controls of the appliance are fi xed to the electrical compartment of the hob. For customer
installation controls are moved in other proper place.
The electrical installation is as follows:
• To perform the electrical connection of the appliance, the deck of the hob must be opened. Lift up the
lid carefylly as it is heavy. Lock the lid to the open position with the support bar.
• Drill mounting holes for thermostats and for pilot lights in new place. The size of mounting holes is
shown on the installation drawings.
Make sure that length of wiring and capillary tube of the
thermostat is enough for installation in new place.
• Take off plastic knob from thermostat axle. Unscrew two screws and release thermostat head with
capillary tube and wiring.
• Pull out the signal lamps with wiring.
• Install thermostat heads and signal lamps in new place.
• Attach bottom back to electrical compartment.
• Return hob in working position.
Positioning of grease box
Recommended position of the grease box is shown on installation drawings.
However grease box can be installed in other place(remote from drain pipe of the hob).For this installation
use suitable type of hose. Connect one end of hose to the drain pipe of the hob and other end of hose
must be located and fi xed so that grease comes right in grease container.
5.4.2. Height adjustable stand
There must be no obstructions in the lifting area at the installation site (radiator tubing, window sash,
electric boxes, etc.).
Adjust the table directly using the adjustable screws on the feet. Check that the table stands fi rmly on
all feet.
Connect the power cord to an approved outlet. Do not use a separate extension cord.
Содержание ARDOX S 4 series
