•
IMPORTANT:
Please read all of the
instructions before
installation.
GENERAL:
This product must be
installed in compliance
with all relevant regional
regulations.
It is the responsibility of
the installer to ensure a
waterproof seal is
achieved between the
product and mounting
surface. If in doubt
about the quality of the
seal, remove the
product and reinstall
using silicone to ensure
a seal is achieved.
All pipe work must be
thoroughly flushed prior
to the installation of the
Hose and Handset (if
supplied).
After installation all
connections must be
checked for leaks.
All outlets used
primarily for personal
hygiene shall deliver
water at a safe
temperature as per
regional regulations.
•
•
•
•
Wall Boss Housing
Grub Srew
Rail
Slider
Internal Mounting
Bracket and Screw
Wall Boss Screws
grub screw
topside
grub screw
underside
Secure the wall boss housings.
NOTE: Ensure protection pads are
used between wall bosses and tiles.
FLOOR
1000mm RAIL
810-945mm
800mm RAIL
570-745mm
1850mm (
recommende
d)
VERTICAL
700mm RAIL
510-645mm
Fitted
Endcap
IF SOAP DISH IS
SUPPLIED:
Slide soap dish
onto the rail
from the end
with the endcap
already fitted.
Fit the internal
mounting brackets
by locating in slot
rotating 90
° as
shown.
Tighten the screws
finger-tight using
Allen key provided.
1.
2.
Match the
mountings
to wall
bosses and
push into
place
Slide the
rail up or
down to
centralise
brackets.
1.
2.
Remove the rail
and tighten the
tensioning
screws until
they lock.
Relocate the rail
onto wall bosses
and tighten grub
screws top and
bottom.
1.
2.
Fit end cap to top of rail.
Ensure drainage hole is
at back.
To adjust slider friction
rotate side piece
anti-clockwise to loosen
and clockwise to tighten.
IF HANDSET, HOSE OR WATER OUTLET ARE SUPPLIED:
Connect hose to water outlet and Methven
handset. Ensure swivelling cone is connected to
the handset.
Non-Swivelling
Cone
Filter Washer
Flat Washer
Handset
(If supplied)
Swivelling
Cone
1.
3.
2.
4.
5.
6.
8.
7.
Water Outlet
(If supplied)
Soap Dish
(If supplied)
Water Outlet
(If supplied)