PN138 N GAUGE
WAYSIDE STATION
INSTRUCTION SHEET 2
PRINTED CANOPY ROOF.
Fig. 12.
Attach the four roof sections starting with the longest front roof,
followed by the two end units then the rear roof.
Glue the grey card all over to stop the top sheets curling up at edges.
Rear canopy roof
The outer edges of the printed roof sections
should be overhanging past the edges of the
plain grey card by about 2mm.
UNDERNEATH THE CANOPY.
Fig. 13.
Turn building over and stand on work surface.
On Grey card item no. 7
there are two tiny pieces
of card shaped like this.
Fold in half and
clean up any
untidy edges,
then fix to underside of
canopy and againts the
building ‘A’ gable wall.
Fit with folded edge
facing away from canopy.
Slightly sloping edge fits
to underside of canopy.
Fit the brackets next.
PLEASE NOTE: There are two brackets that are
slightly smaller that the rest. These fit to the two
shortest canopy supports at the rear of the building
CHECK BEFORE FITTING.
Canopy.
Fit the other 8
larger brackets
(there is an extra
just in case!).
CANOPY EDGING.
Fig. 14.
Starting with the end
strips, (which are the two
shorter ones) fit them so
they sit in the underside
of the printed overhanging
part of the canopy.
Fix up against the grey lower
canopy and the beam ends.
Beam.
Grey.
Printed.
Edging
Fit the end edging strip
so the ends line up with
grey card. Repeat with
other end of building,
then fit the short side
piece shown above.
Finally fit the long front
edging strip and the rear
edging strip.
Note: You can cover the joints
on the corners of the canopy
using the grey roof ridge tile strips.
