Start by cutting out all the
clear plastic window
sections. Cut along the
thin white lines that
mark them out.
Place on a dark piece of
card so you can see them.
This is a fiddly bit, so best to get it over with now.
Start by folding the two
side sections of the bay
window fully back to
loosen the scorelines.
Fold down the top tab
and fix the the side
windows to it.
Fit the small pink tab
inside the bottom of the
bay window.
Allow the glue to set fully before fitting the glazing.
Fig. 1.
START WITH THE WINDOWS.
Fix each of the glazing
sheets to the back of their
corresponding inner
window frames with the
mat printed side facing
through the openings.
Inner
window
frame.
Thin strips of glue.
Fix each of the glazing
sheets to the back of their
corresponding inner
window frames with the
mat printed side facing
through the openings.
Glazing.
NOTE:
Only do the flat windows.
Bay windows are dealt with in Fig.2.
ALSO NOTE;
The two toilet windows fit
directly onto the openings in the side walls
FIT THEM NOW
.
Place the windows
back in your
builders yard
until needed.
Fig. 2.
BAY WINDOWS.
Fig. 3.
DOORWAYS.
Score the glazing
along the dotted
lines very lightly
with the point
of a sharp knife.
GLAZING.
There are four doorways in the main building. They all fit
together in the same way
Glue each to the back of the other so all outer edges are flush.
The toilet door has only one frame
.
Place all the completed door units in builders yard until needed.
Fig. 4.
LARGE CHIMNEY STACK.
Glue the three plain
grey chimney stack
inner formers together
to form a solid block.
(No 12 on Grey Sheet)
Wrap the large
chimney stack
around the block
tightly so the
ends meet.
Stand on a flat
surface and make
sure all edges are
pressed down
flat against it.
Place in builders
yard until needed.
This is another little job to get out of the way before
you get stuck into making the main buildings.
Fig. 5.
BUILDING ‘A’.
Like so!
Carefully bend
the scorelines to form the same
shape as the bay window frame.
Fit inside bay with tiny spots of glue.
Tab.
Door.
Medium.
Large.
Large.
Door frame
Glue the medium door frame
to the back of the large. Then
fix the door to back of medium
frame to give a stepped
relief look like this.
Place in builders yard
until needed.
Fold up end tab.
Building ‘A’ folds around the grey inner floor
(No. 2 on Grey Sheet). The two halves of the
back wall meet butt ended together fixed to
the vertical tab. Keep the floor flat on base
flush with wall bottoms.
Building should look
like this with the
small floor tab
sticking out through
the slot of the back
wall.
Small floor tab.
