12
OPERATION MANUAL
The unpainted surfaces of the machine have been coated with a waxy oil to protect them from
corrosion during shipment. Remove the protective coating with a solvent cleaner or a citrus
based degreaser.
Optimum performance from your machine will be achieved when you clean all moving parts or
sliding contact surfaces that are coated with rust prevented products.
It is advised to avoid chlorine based solvents, such as acetone or brake parts cleaner, as they
will damage painted surfaces and strip metal should they come in contact. Always follow the
manufacturer’s instructions when using any type of cleaning product.
3.2 CLEAN - UP
3.3 SITE PREPARATION
When selecting the site for the machine, consider the largest size of workpiece that will be
processed through the machine and provide enough space around the machine for operating
the machine safely. Consideration should be given to the installation of auxiliary equipment.
Leave enough space around the machine to open or remove doors/covers as required for the
maintenance and service as described in this manual.
It is recommended that the machine is anchored to the floor to prevent tipping or shifting. It
also reduces vibration that may occur during operation.
F
ig
. 3.2
OPTIONS FOR MOUNTING
The machine is best mounted on a concrete slab.
Masonry anchors with bolts are the best way to anchor
machinery, because the anchors sit flush with the floor
surface, making it easy to unbolt and move the machine
later, if needed. (Fig. 3.2)
Metal Shim
Hold Down Bolt
F
ig
. 3.3
To set your machine up so that it operates to optimum
performance, apply the following procedure
After your machine has been anchored to a concrete slab
floor, it then needs to be leveled.
3.4 MACHINE LEVELING
To level the machine:
Loosen the hold down bolts and lightly clamp a piece of
straight steel between the jaws and measure each end
with a tape measure to the floor. Metal shims need to
be placed under corner of the base of the machine until
level and the machine is stable with each corner sitting
firmly on the floor. Once level then tighten the hold
down bolts. (Fig. 3.3).
Содержание S2268
Страница 16: ...16 OPERATION MANUAL SPARE PARTS DIAGRAM...