MetalMaster S2268, Руководство по эксплуатации

Страница: 14 / 20

14
OPERATION MANUAL
5. MAINTENANCE
5.1 CLEANING AND OILING
When finished with the machine always clean down the machine and oil with a light oil all
moving parts and machined surfaces.
Clean both of the jaws when finished. Using an air gun of vacuum will remove the surface dirt
but to clean them properly, disassemble the jaws as follows.
1. Loosen the screw (#61) to separate the jaw assemble, then slide the jaw sidways to remove
the dies. (Fig.5.1)
2. Clean the jaws and V-blocks with cleaning fluid and a brush. Do not use a wire brush or a
wire wheel. Always brush in the same direction as the teeth, with the grooves.
3. Lubricate the surface between the jaws
4. Re-assemble the jaw set.
5. When not in use for extended periods of time, lightly oil the jaws to prevent corrosion.
F
ig
.5.1
Shrinker Dies
Stretcher Dies