Metallkraft UB 10, Инструкция по эксплуатации

Страница: 15 / 22

Special accessories
UB 10 | Version 2.01 15
Example 3
For screws with a length of 315 mm and a thickness of
15 mm, the distance from the eccentric anvil is 6 mm.
Fig. 36: Example 3
The sizes given here are suitable for making 250 mm
long screws. However, you can always vary the length
by simply shortening or lengthening the length. You can
also change the length of the material after curvature by
reducing or extending the length of the eccentric anvil.
Make sure that a sufficient length of material leans
against the counterholder.
9 Special accessories
9.1 Bending segment for spirals
The bending segment is supplied as a separate acces
-
sory and can bend a hot rolled material of 5 x 25 mm.
The edge of the segment bends the material in a spiral. If
you want to make several spirals of the same shape,
mark the top of the bend segment where the first spiral
stops. If you bend the other spirals up to this mark, the si
-
zes of the spirals will all be the same.
Fig. 37: Bending segments for spirals
By bending large and small spirals, you must first insert
the fence and the bend segment into hole 2.
Fig. 38: Insert stop
If you would like to produce a large spiral after the first
phase of bending, remove the stop of the bending seg
-
ment from hole 2 and insert them into hole 5 (at the very
end).
Fig. 39: Making a big spiral
Do not bend a large spiral when the fence and bend seg
-
ment are in hole 5. You need to start with it when in hole
2, otherwise the spiral will not be formed properly.
Fig. 40: Produce a big spiral